video

Motor Bracket Assignment

Handouts in PDF

  • Motor Bracket drawing is not yet available

Below are videos demonstrating the steps to complete this assignment.

In Class 5

DWG Files needed for this lesson:

Below are videos demonstrating the steps to complete each part of this lesson.

Spatula, Setter Bracket, Angle Block Assignments

Handouts in PDF

Below are videos demonstrating the steps to complete each assignment.

In Class 4

DWG File needed for this lesson:

Below is a video demonstrating the steps to complete this lesson.

Bowl and Plate Assignments

Handouts in PDF

Below are videos demonstrating the steps to complete each part of this lesson.

In Class 3

This practice lesson uses the following tools: 

Fillet, 3D Rotate, Revolve, Sweep

DWG File needed for this lesson:

Below are videos demonstrating the steps to complete each part of this lesson.

SolidWorks 2007 Tutorial - Simple Part and Drawing Creation

Drawing of part [ Part1-drawing.PDF ]

Part 1A

  • start a new Part
  • click the Sketch (Sketch commands) button
  • click the Sketch button to the right
  • select the top plane
  • click the Rectangle button
  • choose the first point at the origin and the other above and to the right somewhere
  • click the Select button
  • click the Smart Dimensions button
  • choose the top line and create a dimension above it and make the amount: 3
  • do the same for the line on the right
  • click the Exit Sketch button
  • click the Features (Feature commands) button
  • make sure you rectangle lines are show green if they are not then select the sketch in the list on the left
  • click Extruded Boss/Base button
  • change the depth to: .5
  • click on the OK button

 

Below is a video of the above steps being done.

 
 
Syndicate content